Products
Analytical Instruments
Panner Sales can supply standalone sensors to monitor and control the analytical parameters shown below. We can also integrate signals from the individual sensor points through a multi-parameter instrument.
The HYDRA ammonium analyzer from Electro-Chemical Devices uses ion specific electrodes to measure the concentration of dissolved ammonium in water. The HYDRA features an integrated, submersible sensor with a built-in spray cleaner to reduce maintenance. Measurement electrodes are easily replaced and the analyzer performs corrections for interfering ions and pH compensation. These features provide for the lowest total cost of ownership. Panner Sales offers a free 30 day trial on this unit for you to see for yourself.
To read about the HYDRA in Automation.Com: http://www.automation.com/content/electro-chemical-devices-ecd-fast-and-accurate-hydra-ammonium-analyzer-requires-virtually-no-maintenance
Conductivity is measure of the ability of a material to convey an electric current. In fluids, the conductivity of a solution increases and decreases with the concentration of ions and hence the concentration of dissolved solids. Conductivity is measured in units of microsiemens or PPM of total dissolved solids (TDS).
Panner Sales sells instruments for the measurement, monitoring and control of pH and ORP. The instruments can be used to give a continuous readout of pH and ORP values or they may be integrated with metering pumps, valves, recorders or alarms for a complete system of control.
The Signet Model 4150 turbidimeter system measures water turbidity via a 90 degree light which reflects particles as they flow through a small volume, low flow glass cuvette. This testing method is EPA compliant per USEPA 180.1.
The Signet Model 8900 Multi-Parameter Controller can accept up to six inputs and allows you to configure outputs as necessary for control, measurement or monitoring. You may bring any combination of inputs from Signet instruments including pH/ ORP, flow, conductivity, pressure, temperature or level. You may also connect other manufacturers signals via a 4 to 20 mA signal converter (Signet Model 8058).
The Panner K100 chlorine controller is an amperometric analyzer that can be used for measuring free or total chlorine in water. This analyzer gives a continuous reading of chlorine concentration with an isolated 4-20 mA output and two relay outputs which may be used in the proportional or on/off mode.
The Royce line of PPM level dissolved oxygen analyzers is the largest, most varied in the world. Features like microprocessor-based intelligent electronics, with a choice of rugged, self-cleaning sensors make the totally waterproof Royce line of DO analyzers the best available. Royce offers both continuous and portable DO analyzers.
Royce Technologies offers both continuous and portable instruments for measuring total suspended solids. The Model 7100 Series Analyzer is a single or dual channel unit to continuously measure total suspended solids over a range of 0-80,000 mg/l. The unit displays TSS reading and has two 4-20 mA outputs with two programmable relays per channel. Self-cleaning sensors are available.